View TLP11307_4131927.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

TLP113
TOSHIBA Photocoupler GaAAs IRed & Photo-IC
TLP113
Isolated Line Receiver Simplex / Multiplex Data Transmission Computer-Peripheral Interface Microprocessor System Interface Digital Isolation For A / D, D / A Conversion
The TOSHIBA mini flat coupler TLP113 is a small outline coupler, suitable for surface mount assembly. TLP113 consists of a GaAAs light emitting diode, optically coupled to an integrated high gain, high speed photodetector whose output is an open collector, schottky clamped transistor. Input current thresholds: IF=10mA(max.) Switching speed: 10MBd(typ.) TTL / LSTTL compatible: VCC=5V Guaranteed performance over temp.: 0~70C Isolation voltage: 2500Vrms(min.) UL recognized: UL1577 file no. E67349 Unit in mm
Schematic
IF 1 IO VF 5 VO ICC VCC 6 1
TOSHIBA Weight: 0.09g
11-4C2
Pin Configuration(top view)
VCC 6 5
GND 3 4 3
GND
4
(Note) A 0.1F bypass capacitor must be connected between pins 4 and 6.
1 : Anode 3 : Cathode 4 : GND 5 : Output (Open collector) 6 : VCC
TRUTH TABLE (Positive Logic) INPUT H L OUTPUT L H
1
2007-10-01
TLP113
Absolute Maximum Ratings (Ta = 25C)
Characteristic Forward current Pulse forward current LED Peak transient forward current Reverse voltage Output current Detector Output voltage Supply voltage (1 minute maximum) Output power dissipation Operating temperature range Storage temperature range Lead solder temperature (10s) Isolation voltage (AC, 1 min., RH 60%, Note 4) (Note 1) (Note 2) Symbol IF IFP IFPT VR IO VO VCC PO Topr Tstg Tsol BVS Rating 20 40 1 5 25 7 7 40 -40~85 -55~125 260 2500 Unit mA mA A V mA V V mW C C C Vrms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc). (Note 1) 50% duty cycle, 1ms pulse width. (Note 2) Pulse width1s, 300pps.
Recommended Operating Conditions
Characteristic Input voltage, low level Input current, high level Supply voltage** Fan out (TTL load, each channel) Operating temperature Symbol VFL IFH VCC N Topr Min. -3 13* 4.5 0 Typ. 0 16 5 Max. 1.0 20 5.5 8 70 Unit V mA V C
Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the device. Additionally, each item is an independent guideline respectively. In developing designs using this product, please confirm specified characteristics shown in this document. * 13mA is a guard banded value which allows for at least 20% CTR degradation. Initial input current threshold value is 10mA or less.
**This item denotes operating ranges, not meaning of recommended operating conditions.
2
2007-10-01
TLP113
Electrical Characteristics(unless otherwise specified, Ta=0~70C, VCC=4.5~5.5V,
VFL 1.0V)
Characteristic Forward voltage Forward voltage temperature coefficient Reverse current Capacitance between terminals High level output current Symbol VF VF / Ta IR CT Test Condition IF=10mA, Ta=25C IF=10mA VR=5V, Ta=25C VF=0, f=1MHz, Ta=25C VF=1.0, VO=5.5V VF=1.0, VO=5.5V, Ta=25C IF=10mA IOL=13mA(sinking) IOL=13mA(sinking) VOL=0.6V VCC=5.5V, IF=0 VCC=5.5V, IF=16mA VS=3540V, t=5s Ta=25C R.H. 60%, VS=500V DC Ta=25 VS=0, f=1MHz Ta=25 (Note 4) (Note 4) (Note 4) Min. Typ. 1.65 -2 45 0.5 0.4 Max. 1.80 10 250 10 0.6 Unit V mV / C A pF
IOH
A
Low level output voltage "H level output L level output" input current High level supply current Low level supply current Input-output insulation leakage current Isolation resistance Stray capacitance between input to output
VOL
V
IFH ICCH ICCL IS

7 12
10 15 18 100
mA mA mA A
RS
5x10
10
10
14
CS
0.8
pF
* All typical values are VCC=5V, Ta=25C
3
2007-10-01
TLP113
Switching Characteristics (VCC=5V, Ta=25C)
Characteristic Propagation delay time (HL) Propagation delay time (LH) Output rise-fall time (10-90%) Common mode transient imunity at high output level Common mode transient imunity at low output level CML 2 CMH 2 Symbol Test Cir- cuit 1 Test Condition IF=016mA CL=15pF, RL=350 IF=160mA CL=15pF, RL=350 RL=350, CL=15pF IF=0 16mA Min. Typ. Max. Unit
tpHL
60
120
ns
tpLH
1
60
120
ns
tr, tf
2
30
ns
IF=0mA, VCM=200Vp-p VO(min)=2V, RL=350 IF=16mA, VCM=200Vp-p VO(max)=0.8V, RL=350
200
V / s
-500
V / s
(Note 4) Device considered a two-terminal device: Pins 1 and 3 shorted together, and pins 4, 5 and 6 shorted together. (Note 5) The VCC supply voltage to each TLP113 isolator must be bypassed by 0.1F capacitor, this can be either a ceramic or solid tantalum capacitor with good high frequency characteristic and should be connected as close as possible to package VCC and GND pins of each device. (Note 6) Maximum electrostatic discharge voltage for any pins: 180V(C=200pF, R=0)
4
2007-10-01
TLP113
Test Circuit 1: Switching Time Test Circuit
VCC = 5V
0.1F
Pulse input PW = 100s Duty ratio = 1 / 10 IF monitor
VCC GND
350
IF tf VO tpHL tpLH tr
16mA 8mA 0mA 5V 4.5V 1.5V 0.5V VOL
CL
VO Output monitor
CL is approximately 15pF which includes probe and stray wiring capacitance.
Test Circuit 2: Common Mode Transient Immunity Test Circuit
IF VCC = 5V VCC GND VCM Pulse gen ZO = 50
0.1F 350
VCM tr
90% 10% tf
200V 0V 5V 2V 0.8V VOL
CL
VO Output monitor
VO (IF = 0mA) VO (IF = 10mA)
160(V) 160(V) C = , CL = t f (s) t r (s)
CL is approximately 15pF which includes probe and stray wiring capacitance.
5
2007-10-01
TLP113
IF - VF
100 -4.0
VF / Ta - IF
Forward voltage temperature coefficient VF / Ta (mV / C )
(mA)
10
-3.2 0-25C -2.4 25-70C -1.6
Forward current
IF
1
Ta = 70C 0.1
25C
0C
0.01 1 1.2 1.4 1.6 1.8 2.0
-0.8 0.1
0.3
0.5
1
3
5
10
30
Forward voltage
VF
(V)
Forward current
IF
(mA)
V O - IF
10 VCC = 5V Ta = 25C 5 10
IOH - Ta
VF = 1.0V VCC = 5.5V VO = 5.5V
(V)
High level output current IOH (A)
8
3
VO
6 RL = 350 4 1k 4k 2
Output voltage
1 0.5 0.3
0.1 0 0 0.05 4 6 8 10
2
-20
0
20
40
60
80
Forward current
IF
(mA)
Ambient temperature
Ta
(C)
V O - IF
10 0.50 VCC = 5V 8 RL = 350 RL = 4k
VO L - Ta
IF = 10mA VCC = 5.5V 0.45
(V)
Low level output voltage
VO
6 Ta = 70C 4 Ta = 0C
VOL (V)
0.40
IOL = 16mA 12.8mA
Output voltage
0.35
9.6mA 6.4mA
2
0.30
0
0
2
4
6
8
10
-20
0
20
40
60
80
Forward current
IF
(mA)
Ambient temperature
Ta
(C)
6
2007-10-01
TLP113
tpHL , tpLH - IF
120 RL = 4k 300
tr, tf - Ta
(ns)
RL = 4k
(ns)
100
260 IF=16mA VCC = 5V 220 tf tr 120 RL = 350 1k 4k 80 1k
tpHL, tpLH
Propagation delay time
1k 350 60
40
RL = 350 1k 4k
Ta = 25C VCC = 5V 40
Rise, fall time
80
tr, tf
350
tpHL tpLH
0 16 18 20 -20 0 20 40 60 80
20 10
12
14
Forward current
IF
(mA)
Ambient temperature
Ta
(C)
tpHL , tpLH - Ta
120 RL = 4k
(ns)
100
tpHL, tpLH
80
1k 350
Propagation delay time
60
40
RL = 350 1k 4k IF = 16mA VCC = 5V
20
tpHL tpLH
0 -20 0 20 40 60 80
Ambient temperature
Ta
(C)
7
2007-10-01
TLP113
RESTRICTIONS ON PRODUCT USE
* The information contained herein is subject to change without notice.
20070701-EN
* TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the "Handling Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc. * The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer's own risk. * The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. * The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. * GaAs(Gallium Arsenide) is used in this product. The dust or vapor is harmful to the human body. Do not break, cut, crush or dissolve chemically. * Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations.
8
2007-10-01

▲Up To Search▲

Price & Availability of TLP11307

	To Download TLP11307 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .